Titlebook: Deformation and Failure in Metallic Materials; Kolumban Hutter,Herbert Baaser Book 2003 Springer-Verlag Berlin Heidelberg 2003 Constitutiv

languor

高談闊論

Use of the Elastic Predictor-Plastic Corrector Method for Integrating Finite Deformation Plasticity equations governing the material response is highly nonlinear. To integrate these equations, particular algorithms have been developed, the method of elastic predictor and plastic corrector being often used. This method has turned out to be a very efficient tool, when small deformation plasticity i

釋放

Nebulous

Identification of Material Parameters for Inelastic Constitutive Models: Stochastic Simulationdata using an appropriate optimization algorithm. However, measurement failures and differences in the specimens lead to uncertainties in the determined parameters. Since the amount of test data is not sufficient for a statistical analysis, a method of stochastic simulation is introduced in order to

Intend

A Simple Model for Describing Yield Surface Evolution During Plastic Flow. For metallic materials, deformation induced anisotropy is reflected above all by translation, rotation and distortion of the yield surface. This has been confirmed by several experimental investigations independent of the way the yield point is defined. In the present paper a simple, thermodynamic

Ophthalmoscope

Damage and Failure of Ceramic Metal Composites: Experimental and Numerical Investigationses, a, metal layer between two ceramic supports and an inter-penetrating network, correlated to two different failure modes are studied in detail. Cavitation is found to be one significant mode of (internal) damage, which decreases the strength of the composite and subsequently leads to failure. Int