Titlebook: Soft Computing: Biomedical and Related Applications; Nguyen Hoang Phuong,Vladik Kreinovich Book 2021 The Editor(s) (if applicable) and The

排名真古怪

Soft Computing: Biomedical and Related Applications978-3-030-76620-7Series ISSN 1860-949X Series E-ISSN 1860-9503

cajole

gain631

情愛

Studies in Computational Intelligencehttp://image.papertrans.cn/s/image/870539.jpg

主講人

https://doi.org/10.1007/978-3-030-76620-7Fuzzy Systems; Neural Networks; Machine Learning; Soft Computing; Soft Computing for Biomedical Applicat

interlude

Isaac Bautista,Vladik Kreinovich,Olga Kosheleva,Hoang Phuong Nguyen-Bi solder alloy. Presence of Mo nanoparticles and finer microstructure are believed to be the factors behind the increase. Reinforcing small quantity of Mo nanoparticles to the Sn-Bi solder alloy shows improvement to the microstructure and hardness as well as keeping the melting temperature below 1

Cholagogue

Michal Hol?apek,Viec Bui Quocsamples of RHA concrete were collected from the various reputed journals published within a decade. Water to binder ratio, cement, RHA, water, fine, coarse aggregate and super plasticizer were used as input parameters to develop the models and ultimately to predict strength and durability characteri

得意人

Tuan Linh Dang,Van Chuong Doal and physical evaluations revealed the impact of surface chemical treatments on reinforcements. An optical microscope (SEM) was used to investigate the impact of chemical alteration on composites. Thermogravimetric analysis was used to determine the thermal stability of hybrid composites. Finally,

剝削

Tien Cao-Hoang,Kim Anh Su,Trong Tinh Pham Van,Viet Truyen Pham,Duy Can Nguyen,Masaru Mizoguchis got reduced for 7?wt.% of nanoclay dispersed composites due to its wide agglomeration. Furthermore, better tribological properties were noted for the epoxy composites reinforced with alkali (5% molar concentration of NaOH) treated jute fibers having 20?mm length and weight fraction of 20% along wi

愛了嗎

Olga Kosheleva,Vladik Kreinovich,Hoang Phuong Nguyenresults. An average error percentage of 4.5 and 6.5?% was found when experimental and analytical results were compared for both tensile and compression tests. The fracture surfaces of the tensile and compression specimens were examined using scanning electron microscope (SEM).