Titlebook: New Technologies, Development and Application V; Isak Karabegovi?,Ahmed Kova?evi?,Sadko Mand?uka Conference proceedings 2022 The Editor(s)

重婚

書目名稱New Technologies, Development and Application V影響因子(影響力)




書目名稱New Technologies, Development and Application V影響因子(影響力)學科排名




書目名稱New Technologies, Development and Application V網絡公開度




書目名稱New Technologies, Development and Application V網絡公開度學科排名




書目名稱New Technologies, Development and Application V被引頻次




書目名稱New Technologies, Development and Application V被引頻次學科排名




書目名稱New Technologies, Development and Application V年度引用




書目名稱New Technologies, Development and Application V年度引用學科排名




書目名稱New Technologies, Development and Application V讀者反饋




書目名稱New Technologies, Development and Application V讀者反饋學科排名

過分

Accessible

Multibody Modeling and Dynamical Analysis of a Fixed-Wing Aircraftcode to develop a virtual model capable of simulating the dynamic behavior of the aircraft. Finally, the numerical results found are presented and a discussion on the numerical results is provided, paying attention to the Cessna 172 Skyhawk, which is considered as the case study.

退潮

Investigation of the Influence of tapered Thread Pitch Deviation on the Drill-String Tool-Joint Fatin is the accuracy of the lead angle and pitch. There for these two parameters and their influence on strength are the objects in this research. Increasing the thread pitch in the direction of the larger diameter of the pin taper can lead to a decrease in the fatigue strength of the joint.

不公開

Ambient Light and Object Color Influence on the 3D Scanning Processd the number of registered triangular surfaces on the scans was taken as a relevant result. A rotary table was used in the scanning process. It enabled the scanning of models from all sides of the object by rotating for an angle of 360°.

CRANK

BILL

An Analysis of Heat Affected Zone at Percussion Welding of Austenitic Steel Wiresd joint. All mentioned directly influence on mechanical properties of welded joints. In this paper is analysed the influence of capacity discharge percussion welding parameters on heat affected zone properies of welded joints.

ALLEY

frivolous

Impact of Strain Rate on Plastic Properties of Metalsded with an impulse load shows that plastic deformation occurs by twinning and sliding within the grain. During this load, elastic-plastic waves occur in the workpiece, where the magnitude of the stress is related to the speed of propagation of the wave.

偽書

Design of a Digital Twin of a Robotic Cell for Product Quality Controlration of the virtual cell is verified by simulating a cycle consisting of transporting the product via conveyor belts through the safety door into the quality control cell, where inspection is performed using the UR5 robotic arm.