Titlebook: New Production Technologies in Aerospace Industry; Proceedings of the 4 Berend Denkena Conference proceedings 2014 Springer International P

metabolism

書目名稱New Production Technologies in Aerospace Industry影響因子(影響力)




書目名稱New Production Technologies in Aerospace Industry影響因子(影響力)學科排名




書目名稱New Production Technologies in Aerospace Industry網絡公開度




書目名稱New Production Technologies in Aerospace Industry網絡公開度學科排名




書目名稱New Production Technologies in Aerospace Industry被引頻次




書目名稱New Production Technologies in Aerospace Industry被引頻次學科排名




書目名稱New Production Technologies in Aerospace Industry年度引用




書目名稱New Production Technologies in Aerospace Industry年度引用學科排名




書目名稱New Production Technologies in Aerospace Industry讀者反饋




書目名稱New Production Technologies in Aerospace Industry讀者反饋學科排名

Blemish

不給啤

Simulation of the NC Milling Process for the Prediction and Prevention of Chatter,fectiveness of the simulation approach and of the compensation strategy, a comparison is shown between experimental and simulated results and between the workpiece generated by the original and the optimized NC programs.

Cerumen

Surface Characterization of Components Subjected to Deep Rolling for Cyclic Loading Applications, the specimens after turning shifted to compressive stress after deep rolling. In contrast to the residual stress values, which did not present a straightforward relationship with deep rolling parameters, the full width at half maximum values indicated that more accentuated work hardening is obtained when rolling pressure is elevated to 200?MPa.

MEET

ATP861

Simulation of Residual Stress Related Part Distortion,piece. An experimental verification is given by comparing measured part distortions caused by a manufacturing process and predicted by the developed simulation. The Validation is done on a complex structural part. The simulation results show good agreement between simulated and measured part distortions.

armistice

Increasing Accuracy of Industrial Robots in Machining of Carbon Fiber Reinforced Plastics,orce of the attached robot structure. Therefore, the IR is mounted on an inclined base. The performance of this setup is experimentally evaluated. Improvements of up to 50?% in terms of static stiffness, deviation of circular movement and contour accuracy in edge milling have been achieved.

Ancestor

Conference proceedings 2014e conference are new production technologies in aerospace industry and the focus is on energy efficient machine tools as well as sustainable process planning. The target audience primarily comprises researchers and experts in the field but the book may also be beneficial for graduate students.

Costume

Flexible Production of Small Lot Sizes by Incremental Sheet Metal Forming with Two Moving Tools,cerning geometrical accuracy, part complexity and surface quality. Also solutions for forming of advanced materials as magnesium or titanium alloys are being developed, which shows a high potential for the production of lightweight sheet metal parts, as used in aerospace industry.

關心