Titlebook: Metal Forming Interrelation Between Theory and Practice; Proceedings of a sym A. L. Hoffmanner (Principal Engineer) Conference proceedings

Manipulate

書目名稱Metal Forming Interrelation Between Theory and Practice影響因子(影響力)




書目名稱Metal Forming Interrelation Between Theory and Practice影響因子(影響力)學科排名




書目名稱Metal Forming Interrelation Between Theory and Practice網絡公開度




書目名稱Metal Forming Interrelation Between Theory and Practice網絡公開度學科排名




書目名稱Metal Forming Interrelation Between Theory and Practice被引頻次




書目名稱Metal Forming Interrelation Between Theory and Practice被引頻次學科排名




書目名稱Metal Forming Interrelation Between Theory and Practice年度引用




書目名稱Metal Forming Interrelation Between Theory and Practice年度引用學科排名




書目名稱Metal Forming Interrelation Between Theory and Practice讀者反饋




書目名稱Metal Forming Interrelation Between Theory and Practice讀者反饋學科排名

浪蕩子

晚來的提名

The Effect of Material Properties on Tension Zone and Boundary Shear-Stress in Extrusiontric extrusion process of extrusion ratio 4 and a half cone angle of 45°. The extrusion speed was 0.1/min for aluminum and.003 in/min for superplastic Pb-Sn. The stress components along and perpendicular to the flow lines were calculated for different values of workhardening and strain-rate exponent

財產

放氣

The Extrusion of Rate Sensitive Materialsmphasis is given to the importance of determining the area profile of the die, and through it the strain rate profile. Four different definitions of the mean strain rate are considered, and it is shown that the root mean power strain rate is the appropriate one to use for working load calculations.

嫌惡

inscribe

The Effect of Homogeneity on the Formability of 7000 Series Aluminum Alloys for Cartridge Casesieved; the main problem appears to be burn throughs which infrequently occur in the side wall of the cases. The nature of the failure is such that (i) severe damage occurs to the weapon upon burn-through and (ii) failure analysis is difficult. The general interpretation is that small tears occur dur

DAFT

Effect of Plastic Anisotropy on Drawing Characteristics of Aluminum Alloy Sheet good drawability, a fine grain size, and minimum earing tendencies. The latter property is one manifestation of anisotropy for which control is attempted by means of fabricating practices designed to balance annealing and rolling crystallographic textures.

Harridan

Analyses of Deformation and Texture as Functions of Fabrication in Mandrel-Drawn Tubing00 MWe boiling water reactor requires almost 500,000 ft of nominally l/2-in.-diam Zircaloy tubing per core loading. The production of such tubing is potentially a very large-scale operation with the advent of increasing numbers of power reactors. We are presently concerned with the effects that fabr

RODE