Titlebook: Low density cellular plastics; Physical basis of be N. C. Hilyard (Honorary Research Fellow),A. Cunnin Book 1994 Springer Science+Business

殘忍

Polyurethane flexible foam formation,lding and extrusion, or by pouring in place, these materials are either open or closed cell, or somewhere between the two. In open cell foams the gas cells are interconnected, while in a closed cell foam each cell is totally enclosed by thin plastic walls [1–4].

Tonometry

Characterization of polymeric cellular structures,be considered before undertaking such a characterization are whether it should be qualitative or quantitative, what is to be characterized, what will the results mean and to what purpose will the results be put?

critic

febrile

Heat transfer in foams,large volume fraction of gas which has a much lower thermal conductivity the resultant conductivity of the foam is much less than that of a solid body made of the same material. In this chapter the foam conductivity refers to the effective value exhibited by the foam. It is the ratio of the rate of

天賦

Thermal ageing,on-encapsulated foam tends to increase with time due to an effusion of the blowing agents and an infusion of air. This causes the gas composition in the foam cells to change with time. As air has a higher thermal conductivity than the blowing agents a thermal ageing occurs. Essentially, the mechanis

Extort

The elastic behavior of low-density cellular plastics,rticular are available with a broad range of mechanical response because they can be produced with substantially different cell structure and they can also be produced from substantially different polymers. The practical desire to engineer cellular plastics, which we will also refer to as foams, mot

MUMP

Hysteresis and energy loss in flexible polyurethane foams, are the main functional attributes, is governed by two material properties: the effective stiffness; and energy lost through hysteresis under the conditions that prevail in use. In most applications the foam is subject to combined stresses (tension, shear and compression) and in some characterizati

易達(dá)到

Impact response,used to protect electronic products during transit, or those used to protect humans during hazardous activities, will take precedence over those where the main design criteria are for static or low frequency dynamic loading. The definition of impact varies with the field of application; Macauley [1]

CHURL

要塞

diterran gepr?gten Süden und sind deswegen eine deutliche Grenzmarke zwischen zwei nicht nur im landschaftlichen Erscheinungsbild, sondern auch klimatisch v?llig unterschiedlichen Gro?r?umen. über rund 1200 km L?nge erstrecken sich die alpinen H?hen vom markanten Westalpenbogen, der an der franz?sis