Titlebook: Integratives M&A-Management; Entwicklung eines ga Florian A. Bauer Book 2012 Gabler Verlag | Springer Fachmedien Wiesbaden 2012 nn

無感覺

書目名稱Integratives M&A-Management影響因子(影響力)




書目名稱Integratives M&A-Management影響因子(影響力)學科排名




書目名稱Integratives M&A-Management網絡公開度




書目名稱Integratives M&A-Management網絡公開度學科排名




書目名稱Integratives M&A-Management被引頻次




書目名稱Integratives M&A-Management被引頻次學科排名




書目名稱Integratives M&A-Management年度引用




書目名稱Integratives M&A-Management年度引用學科排名




書目名稱Integratives M&A-Management讀者反饋




書目名稱Integratives M&A-Management讀者反饋學科排名

凈禮

her Denkschulen der Pre-Merger-Phase (strategische Komplementarit?t und kulturelle Kompatibilit?t) mit Themenbereichen der Post-Merger-Phase (Integrationsgrad und Integrationsgeschwindigkeit) verbindet und deren Wechselwirkungen mit dem M&A-Erfolg analysiert.978-3-8349-3209-9978-3-8349-6962-0

inveigh

保守黨

Stand der M&A-Forschung, Problemfelder und Untersuchungsziel,definiert werden, anschlie?end wird in Form eines selektiven Literatur Review ein aggregiertes Bild bisheriger empirischer Arbeiten erstellt, um eine Bewertung des Forschungsstandes zu wagen. Die nachfolgende Abbildung ordnet das Kapitel 3 in den Gang der Untersuchung ein.

Texture

分離

直覺沒有

zed. In this paper, the basic relationship between the cutting edge geometry and the burr formation in machining ductile materials with depths of cut below 50?μm will be investigated. In particular, the influences of the material, the tool cutting edge radius and the tool cutting edge angle on the c

誘拐

Florian A. Bauer workpiece properties. Numerous investigations have been presented on this field in the last years, but the reached expertise can’t be transferred to micro-machining. Based on the rising influence of the grain structure in micro-machining, certain size effects occur when scaling the cutting process

現實

Florian A. Bauer workpiece properties. Numerous investigations have been presented on this field in the last years, but the reached expertise can’t be transferred to micro-machining. Based on the rising influence of the grain structure in micro-machining, certain size effects occur when scaling the cutting process

Range-Of-Motion

Florian A. Bauerware judges by these borders, if for a certain parameter set point, either chip breakage or unfeasible chip shapes occurs. Inter- and extrapolations for so far unknown datasets are also based on the borders. These operations are operating with correction values and the data output is combined with a