Titlebook: ;

爆米花

有助于

N. J. Cotton,M. W. Raynor,K. D. BartleContainer corner castings are required to be certified in accordance with the requirements prescribed in this Chapter.

帽子

Certification Procedure,The certification procedure outlined below is a typical procedure which will facilitate the certification of offshore containers in accordance with the guidance outlined in this guide. That said, Class may consider alternative procedures, provided they are no less effective than the requirements indicated in this guide.

報復(fù)

Quality Assessment,In general, the quality assessment will consist of a review of the quality manual and audit of the facility to verify manufacturing is performed in accordance with the manual.

Rejuvenate

Offshore Container Design,This chapter specifies the requirements for the design, manufacture and marking of offshore freight, waste skip and service containers intended for repeated use to, from and between fixed or floating installations and ships.

Chivalrous

Materials and Welding,Materials made of steel must be suitable for the intended service conditions. This means they must be of good quality, free of defects, and are to exhibit satisfactory formability and weldability characteristics. Materials other than steels are to be specially considered during the Class review.

協(xié)奏曲

Design,All offshore containers are to be designed and constructed such that they can withstand impact loads resulting from heavy seas or contact with any structure during transportation. The design is to facilitate loading and unloading operations while the vessel is operating at a maximum wave height of 6?m (20 ft).

摘要

Production and Manufacture of Offshore Containers,Offshore containers are to be manufactured in compliance with the Class approval letter, approved drawings and specifications, which are to be made available to the Class Surveyor upon their request.

Thyroxine

Offshore Container Marking and Data Plates,In case the roof of the container is recessed below the top rail, the top surface of the top rail is to be marked at a minimum.

AXIS