Titlebook: Enhanced Material, Parts Optimization and Process Intensification; Proceedings of the F Uwe Reisgen,Dietmar Drummer,Holger Marschall Confer

貪求

書目名稱Enhanced Material, Parts Optimization and Process Intensification影響因子(影響力)




書目名稱Enhanced Material, Parts Optimization and Process Intensification影響因子(影響力)學科排名




書目名稱Enhanced Material, Parts Optimization and Process Intensification網絡公開度




書目名稱Enhanced Material, Parts Optimization and Process Intensification網絡公開度學科排名




書目名稱Enhanced Material, Parts Optimization and Process Intensification被引頻次




書目名稱Enhanced Material, Parts Optimization and Process Intensification被引頻次學科排名




書目名稱Enhanced Material, Parts Optimization and Process Intensification年度引用




書目名稱Enhanced Material, Parts Optimization and Process Intensification年度引用學科排名




書目名稱Enhanced Material, Parts Optimization and Process Intensification讀者反饋




書目名稱Enhanced Material, Parts Optimization and Process Intensification讀者反饋學科排名

現存

Metallographic Comparison for Laser Welding of Cu-ETP and CuSn6 with Laser Beam Sources of 515?nm anprocessing of parts in the micron range but reduces the surface quality of the parts at the same time. Laser beam sources with a wavelength in the near infrared range have established themselves for this purpose. Laser beam sources in the visible wavelength range however prove to be an alternative d

中國紀念碑

Numerical Investigation of Keyhole Depth Formation in Micro Welding of Copper with 1030?nm and 515?nof the keyhole depth are based on an approximate process model for the three-dimensional steady keyhole profile and carried out for laser beams of the wavelengths 1030?nm and 515?nm with equal intensity distributions in the beam waist. It is found that under standard process conditions deeper keyhol

啤酒

他日關稅重重

Validation of the EDACC Model for GMAW Process Simulation by Weld Pool Dimension Comparisonurrent density distribution on the surface of the weld pool in gas metal arc welding (GMAW). To validate the model, geometry parameters available from experiments from GMAW processes were compared to the corresponding geometry parameters from simulations. The process simulation model was supplied wi

花費

花費

古代

TiOx/Cr2O3 Heating Coatings for Injection Molding of Polyamides or require additional process steps. A heating system applied directly on the cavity surface of the mold tool combines two benefits: high temperature gradients without additional process steps. In this study, a heating coating made of TiO./Cr.O. was applied on the surface of a tooling steel to con

legitimate

無表情

Simplex Space-Time Meshes for Droplet Impact Dynamicsonality. This paper highlights an axisymmetric interface-capturing method [., .]. The level-set method is used for modeling the evolution of the front, because of its inherent ability to account for large topological changes of the interface [.], and is combined with a continuum surface force (CSF)