Titlebook: Cold Micro Metal Forming; Research Report of t Frank Vollertsen,Sybille Friedrich,Hans-Werner Zoc Book‘‘‘‘‘‘‘‘ 2020 The Editor(s) (if appli

GREEN

neutralize

Assignment

Seriation, Stratigraphy, and Index Fossilseveral thousands (e.g. in medical technology) to literally billions (e.g. resistor end caps in the electronics industry). Moreover, such micro parts are often produced under severe cost pressure, with the market price for an individual part often being only a fraction of a € cent.

Debrief

Process Design,everal thousands (e.g. in medical technology) to literally billions (e.g. resistor end caps in the electronics industry). Moreover, such micro parts are often produced under severe cost pressure, with the market price for an individual part often being only a fraction of a € cent.

夾死提手勢

Introduction to Collaborative Research Center Micro Cold Forming (SFB 747),iaturisation in many industries. The main boosters for this trend are currently the consumer and communication electronics market and—to a lesser extent—medical technology (especially microfluidic devices, which had a market volume of approx. $2.5B in 2017 [.]).

合法

Process Design,l challenges. Generally speaking, in most industries micro production tends to be characterized by mass production, meaning very high lot sizes from several thousands (e.g. in medical technology) to literally billions (e.g. resistor end caps in the electronics industry). Moreover, such micro parts a

consolidate

Materials for Micro Forming,drawing are typically made of highly ductile materials such as pure aluminum, copper or stainless steel. Yet these materials are not suited for deep drawing of high strength micro components. Alloys with high mechanical strength are not available as thin foils below 50?μm due to significant strain h

Delirium

8樓

初次登臺

9樓

闡釋

9樓