Titlebook: An Introduction to Surface-Micromachining; Robert W. Johnstone,M. Parameswaran Book 2004 Springer Science+Business Media New York 2004 LIG

支票

書目名稱An Introduction to Surface-Micromachining影響因子(影響力)




書目名稱An Introduction to Surface-Micromachining影響因子(影響力)學科排名




書目名稱An Introduction to Surface-Micromachining網絡公開度




書目名稱An Introduction to Surface-Micromachining網絡公開度學科排名




書目名稱An Introduction to Surface-Micromachining被引頻次




書目名稱An Introduction to Surface-Micromachining被引頻次學科排名




書目名稱An Introduction to Surface-Micromachining年度引用




書目名稱An Introduction to Surface-Micromachining年度引用學科排名




書目名稱An Introduction to Surface-Micromachining讀者反饋




書目名稱An Introduction to Surface-Micromachining讀者反饋學科排名

scoliosis

CRUE

somnambulism

Mechanicsowever, at minimum, a grounding in structural mechanics and beams is necessary. This chapter will provide a brief introduction to the subject. More dedicated readers are referred to Timoshenko and Gere [1], a standard introduction to mechanics.

gregarious

Non-Ideal Processes when deposition occurred. The result of any processing step therefore depends heavily on the preceding steps. Managing topography is an important part of the design process. Generally, design faults relating to topography can be classified into three categories: interference faults, structural faults, and behavioural faults.

雀斑

ILEUM

Electro-Thermal-Compliant Actuatorss to flow throughout the device, which cause the temperature to rise due to Joule heating. ETC actuators use the resulting thermal expansion to create motion. Typically, they also have some method of amplifying these small displacements into useable motion.

錯

Raised Structurescation. Even a very small chip will be several millimetres on a side. However, the total height of the thin-films will typically be measured in microns. Thus, surface-micromachined devices are quite constrained in this one direction.. This small vertical range can be a disadvantage.

Lethargic

PIZZA

Die Zukunft des deutschen Gesundheitswesensmanufacturing processes. They should then build upon this knowledge by learning the basic design techniques used in surface-micromachining. Finally, new designers should learn any specific device knowledge and theory required. Figure 1.1 outlines this hierarchy.