Titlebook: Advances in Manufacturing Processes; Select Proceedings o Harshit K. Dave,Dumitru Nedelcu Conference proceedings 2021 The Editor(s) (if app

離開(kāi)就切除

勉強(qiáng)

Co-Creation in Higher Educationf FSW joints. The tool rotational speed and weld speed were varied from 545 to 1070?rpm and 20 to 50?mm/min, respectively. In order to study the effect of individual process parameters on joint tensile strength, bottom-up approach was used. It is observed that at 765?rpm and 20?mm/min process condition, maximum tensile strength was obtained.

cleaver

ADORE

978-981-15-9119-8The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Singapor

入會(huì)

保全

https://doi.org/10.34156/978-3-7910-5064-5achieve desire surface qualities. In this paper, the effect of circular and point-to-point interpolation on the surface finish and form is investigated on a spherical disk with deep radius. Taguchi L. array is used to conduct the experiments on polymethylmethacrylate (PMMA). The machining parameters

眉毛

https://doi.org/10.34156/978-3-7910-5064-5s on hard material. In this research work, through hole has been drilled on AISI 304 material using solid and tubular tool of copper material. The performance of electro-discharge drilling process has been measured in terms of material removal rate, tool wear rate and surface roughness. Further, the

Nonflammable

到婚嫁年齡

The Basic Assumptions of Co-creation,h a highly efficient and focused approach to manufacturing effectiveness. Study has been made on effect of wire electrode material and wire diameter on WEDM performance of aluminium metal matrix material Al+SiC has been reported. Plain brass and zinc coated brass wire having diameter 0.25 and 0.3?mm

陳舊

The Eight Steps of the Co-creation Process,n some electrically assisted non-conventional machining methods find difficulty to develop features on such materials owing to their non-conducting nature. Microslots are developed on quartz glass slices through Wire electrochemical discharge machining process using zinc-coated brass wire with 0.1?m