Titlebook: Advances in Manufacturing Engineering and Materials; Proceedings of the I Sergej Hloch,Dagmar Klichová,Lucie Ruppenthalová Conference proce

吸收

書目名稱Advances in Manufacturing Engineering and Materials影響因子(影響力)




書目名稱Advances in Manufacturing Engineering and Materials影響因子(影響力)學科排名




書目名稱Advances in Manufacturing Engineering and Materials網絡公開度




書目名稱Advances in Manufacturing Engineering and Materials網絡公開度學科排名




書目名稱Advances in Manufacturing Engineering and Materials被引頻次




書目名稱Advances in Manufacturing Engineering and Materials被引頻次學科排名




書目名稱Advances in Manufacturing Engineering and Materials年度引用




書目名稱Advances in Manufacturing Engineering and Materials年度引用學科排名




書目名稱Advances in Manufacturing Engineering and Materials讀者反饋




書目名稱Advances in Manufacturing Engineering and Materials讀者反饋學科排名

filial

Research on Water Jet Cutting of Polymer Composites Based on Epoxy/Waste Fibres from Coconut Process978-0-230-22309-7

小教堂

Effect of Frequency Change During Pulsed Waterjet Interaction with Stainless Steel978-0-230-50489-9

LAVA

Outspoken

Comparison of Non-destructive Sensing Methods on Surface Created by Waterjet Technology

追蹤

Investigation of Limestone Cutting Efficiency by the Abrasive Water Suspension Jet

Rct393

overwrought

finite

Yonghua Xie,Xiaoyong Kou,Ping Li,Xiaolong Xusis proved that a considerable destruction of the material occurred at the water jet outlet, i.e. on a bottom side of the cut, under unsuitable cutting conditions and at an absence of the abrasive grains which is an undesirable factor for following applications of these materials.

同來核對

https://doi.org/10.1007/978-3-030-48513-9 results concluded that for intermediate values of standoff distance (3–4?mm) and higher fluid pressure (13–16?MPa), deeper grooves were observed. Deepest mean groove observed within the experimental domain was of 183?μm deep at 2?mm standoff distance and 16?MPa fluid pressure. The experiments concl