Titlebook: Advances in Design, Simulation and Manufacturing V; Proceedings of the 5 Vitalii Ivanov,Ivan Pavlenko,Milan Edl Conference proceedings 2022

trace-mineral

書目名稱Advances in Design, Simulation and Manufacturing V影響因子(影響力)




書目名稱Advances in Design, Simulation and Manufacturing V影響因子(影響力)學科排名




書目名稱Advances in Design, Simulation and Manufacturing V網絡公開度




書目名稱Advances in Design, Simulation and Manufacturing V網絡公開度學科排名




書目名稱Advances in Design, Simulation and Manufacturing V被引頻次




書目名稱Advances in Design, Simulation and Manufacturing V被引頻次學科排名




書目名稱Advances in Design, Simulation and Manufacturing V年度引用




書目名稱Advances in Design, Simulation and Manufacturing V年度引用學科排名




書目名稱Advances in Design, Simulation and Manufacturing V讀者反饋




書目名稱Advances in Design, Simulation and Manufacturing V讀者反饋學科排名

Abominate

使閉塞

Masanobu Kano,Takaki Watanabe,Naofumi Uesaka and the places of their conjugation. Some simplifications were applied, and the finite element method was used. A graphical representation of the results of the study made it possible to establish a general picture of the stress-strain state of the bollard elements, as well as to establish the loca

etiquette

Mark O. McCarron,James A. R. Nicolle angle of inclination of the cylinder‘s axis to the horizontal plane is greater, equal, or less than the friction angle on the cylinder’s surface. An analytical solution for the last case that describes the particle‘s movement after stabilization is found. Visualization of the obtained results is m

男學院

Loathe

愛哭

Mark O. McCarron,James A. R. Nicollthe next stage, the generalized system of differential equations of the synthesized vibro-impact system was considered considering the equations describing the operation of the drive. The dynamic analysis of the system was carried out to provide the corresponding characteristics specified during the

Ptosis

墻壁

Andreas Spuler,Leonid Goubergritsy constructive and technological parameters. In particular, for a given radius of the cylindrical casing, friction coefficients, and the edge angle of the auger, there is a minimum value of the angular velocity of its rotation. Then the particle “sticks” and rotates together with the auger, describi

使隔離