標題: Titlebook: Recent Trends in Product Design and Intelligent Manufacturing Systems; Select Proceedings o B.B.V.L. Deepak,M.V.A. Raju Bahubalendruni,Bibh [打印本頁] 作者: 母牛膽小鬼 時間: 2025-3-21 18:43
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems影響因子(影響力)
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems影響因子(影響力)學科排名
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems網絡公開度
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems網絡公開度學科排名
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems被引頻次
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems被引頻次學科排名
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems年度引用
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems年度引用學科排名
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems讀者反饋
書目名稱Recent Trends in Product Design and Intelligent Manufacturing Systems讀者反饋學科排名
作者: novelty 時間: 2025-3-21 22:06
confronted with complex antigens, CD8+ T cells respond to only a few “immunodominant” epitopes and neglect other “cryptic” peptides that would otherwise be immunogenic when presented alone. Immunodominant epitopes are better immunogens than cryptic epitopes. Compared with T cells specific for crypt作者: 放肆的你 時間: 2025-3-22 01:33
Suyash Krishna,Sangeeta Pandit,Rajat Kamble,Jigyasa Hemant Patankaring look promising, then the materials are incorporated into a blade and certified through a full-scale blade test. The coupon testing is not always representative of performance of the new materials, and full-scale-blade testing is time consuming and very expensive—on the order of several hundred t作者: 燒烤 時間: 2025-3-22 05:18 作者: 挑剔為人 時間: 2025-3-22 11:18
Chelapareddi Anshuman Rao,Bangaru Sai Prakesh,Sangeeta Pandit under deformation, resulting in unexpected failure without significant necking. Therefore, an extensive study was initiated to gain insight on the formation and development of microstructural damage in dual phase (DP) steel from a mechanical point of view..Different DP (model) microstructures were 作者: 棲息地 時間: 2025-3-22 14:53 作者: 郊外 時間: 2025-3-22 17:08 作者: 課程 時間: 2025-3-22 22:34 作者: 十字架 時間: 2025-3-23 04:25
ne milieu, endogenous protection may be reestablished or even enhanced. It is therefore no surprise that cytokine immunotherapy holds great theoretical promise for the treatment of cancer. This theoretical promise has been borne out in a wide variety of preclinical models but unfortunately, clinical作者: PACT 時間: 2025-3-23 08:11 作者: 提名的名單 時間: 2025-3-23 13:11 作者: 流動才波動 時間: 2025-3-23 13:53
Sangeeta Pandit,Rajat Kamble,Avinash Sahu,Bangaru Sai Prakash,Vishal Patild finally, a strain hardening region up to densification of the foam. The characteristic stresses of the stress-strain behavior vary linearly with the logarithm of strain rate. A general three-dimensional elastic-viscoplastic model, formulated in strain space, was proposed. The model expresses the m作者: Injunction 時間: 2025-3-23 21:50 作者: 食道 時間: 2025-3-23 22:16
R. Naveen Kumar,S. Shankar,R. Nithyaprakash,T. V. Srinivasan,R. Sunil Kumaur,A. K. N. Venkatachalanow characterization is performed using an array of piezo-electric pressure sensors. Panel deformation is measured using three-dimensional digital image correlation. Experimental data will be used to determine the validity of the multi-physics solver as an engineering design tool.作者: armistice 時間: 2025-3-24 04:25 作者: 原告 時間: 2025-3-24 08:56
Jitender Singh,Prabir Sarkare and reliable results than X-ray diffraction for this particular part and material. A good agreement between residual stress measurement and FEA prediction has demonstrated that the integrated residual stress model is robust in predicting residual stresses and optimizing heat treatment of aluminum 作者: Musket 時間: 2025-3-24 12:44
Sangeeta Pandit,Gaurav Pralhad Chindarkar,L. Dillieshwar Rao,Siddharth Das,Avinash Sahu,Rajat Kamble作者: 其他 時間: 2025-3-24 16:08
Sangeeta Pandit,Shubham Kumar Thakur,Trushna Gopalrao Khalode,Aakriti,Avinash Sahu,Rajat Kamble作者: 驚惶 時間: 2025-3-24 20:11 作者: acolyte 時間: 2025-3-25 00:02 作者: Amendment 時間: 2025-3-25 05:03
Prem Sangam Mishra,Eshaan Gupta,Amitabh Das,Manasi A. Kanetkar作者: frenzy 時間: 2025-3-25 09:45 作者: STALE 時間: 2025-3-25 15:02
Nikita Venkatesh Mishra,Amiya Dash,Shuvabrata Bandopadhaya作者: 我怕被刺穿 時間: 2025-3-25 18:04 作者: GUISE 時間: 2025-3-25 22:56
Recent Trends in Product Design and Intelligent Manufacturing SystemsSelect Proceedings o作者: 倔強不能 時間: 2025-3-26 00:19
2195-4356 , production and industrial engineering, especially those working on improvements in manufacturing technologies and development of resilient infrastructure in industry..978-981-19-4608-0978-981-19-4606-6Series ISSN 2195-4356 Series E-ISSN 2195-4364 作者: 喧鬧 時間: 2025-3-26 08:11 作者: GROG 時間: 2025-3-26 10:30 作者: 熟練 時間: 2025-3-26 13:10
Bio-inspired Design of Octafilar, Hexafilar and Quadrifilar Helical Springsen fibre in the intralingual sheaths of a chameleon‘s ballistic tongue. So after designing these springs, finite element analysis (FEA) which includes stress, strain, deformation and factor of safety (F.O.S), was performed to confirm the functioning of design, and also, modal analysis was performed 作者: 到婚嫁年齡 時間: 2025-3-26 19:43 作者: FLAG 時間: 2025-3-27 00:23
Arduino-Based Unmanned Vehicle to Provide Assistance Under Emergency Conditions maintain the balance of the drone in tough conditions. The final outcome of this project supports ranger unit, victims of catastrophes and helps to identify surroundings of victims using Unmanned Aerial Vehicles (Quadcopter).作者: 范例 時間: 2025-3-27 04:06
Analysis of Secondary Tasks Performed and Psychosocial Factors of Railway Loco Pilotsot are driving on long-distance routes through various environmental conditions, attention to signalling system, overnight stay in various locations, stretchable working hours, improper work-rest cycle and sighting different undue incidents on the railway track. This paper aims to understand the eff作者: sultry 時間: 2025-3-27 06:56
Instructions for the Preparation Intervention of Shoulder Load Carrier for Porters Working in Vegetae such sector where MMH is very high is the vegetable mandi. Lifting, lowering, pushing, pulling, carrying, holding, and releasing several tons of vegetable and fruits are commonly observed in these mandis in several parts of India. Musculoskeletal disorders (MSDs) are commonly observed among porter作者: 畏縮 時間: 2025-3-27 11:45
Design Intervention in the Manually Push Cart Used for Carrying the Vegetables in Hyderabadl loaded vegetable cart which approximately weighs 150–200?kgs through different road terrains. The small handle of the existing cart design is very difficult for pushing and turning purposes. Ten vegetable vendors were questioned regarding musculoskeletal problems at Mehdipatnam, Hyderabad. Among t作者: reptile 時間: 2025-3-27 17:32
Critical Posture Analysis During the Handling of Water Barrel with and Without Exoskeletont. The purpose of this study is to evaluate the risk involved in adopted work postures during the handling of domestic water barrels (25?L). An exoskeleton design is proposed to reduce the consequence of the manual handling of water barrels. The Rapid Entire Body Assessment (REBA) method and the Man作者: largesse 時間: 2025-3-27 19:03
A Graphical User Interface (GUI) System for a Stationary Trainer Used in Lower Limb Rehabilitationnary trainer based on Cartesian parallel manipulator. The trainer is configured with three legs of PRRR (prismatic-revolute-revolute-revolute) configuration connected to the end-effector. The end-effector of the mechanism is a footplate to which the subject’s foot can be attached for therapeutic pro作者: 發微光 時間: 2025-3-27 23:41 作者: Retrieval 時間: 2025-3-28 05:16 作者: 比喻好 時間: 2025-3-28 09:11 作者: 寬敞 時間: 2025-3-28 11:47 作者: xanthelasma 時間: 2025-3-28 15:06
Tribological Behavior of Co–Cr–Mo Alloy on Ultra High Molecular Polyethylene With and Without Third l applications and Bio-inerts lime hip implants, ophthalmological implants and dental implants are increasing day by day due to their unique wear resistance characteristics. This paper presents the tribological behavior of Co–Cr–Mo alloy on Ultra high molecular polyethylene with and without third bo作者: 休戰 時間: 2025-3-28 21:46 作者: Resistance 時間: 2025-3-28 23:30 作者: Feigned 時間: 2025-3-29 05:44 作者: 不透明 時間: 2025-3-29 11:13
Numerical Analysis for Roof Rack Crossbar Wind Noise Prediction and Minimizatione’s equation is used to resolve the time-dependent effects of the flow turbulence. The pressure data of a point in the flow domain is processed to obtain the wind noise in terms of sound pressure level (SPL). An aerodynamic problem involving a right circular cylinder is used to validate the CFD mode作者: 粗魯性質 時間: 2025-3-29 14:11
Development of Close Celled Cenosphere Based Polymer Syntactic Foams in weight of the structures reduces the energy demand to carry them. Syntactic foams are porous particle reinforced composite materials. The porosity was achieved by using hollow micro balloons as reinforcements. In the present study, cenospheres obtained from thermal power plants were used as rein作者: COST 時間: 2025-3-29 15:45
Design of Snake Robot with 28015 PING Ultrasonic Distance Sensor and Arduinoighly fitted for confined surroundings as they can enter and travel through these places with a higher degree of freedom because of their small cross section and highly redundant kinematics. The first focus of SnakeBot is to copy the movement of the similar named reptile-the serpent. The discussed d作者: artifice 時間: 2025-3-29 23:37
Arduino-Based Unmanned Vehicle to Provide Assistance Under Emergency Conditionsll decide the endings of lives, it’s humanly impossible to reach out & save everyone. Navigating some unique places (narrow paths, multi-story buildings), to do the rescue service are critical. One can solve this issue by deploying an Unmanned Aerial Vehicle (Quadcopter Drone), which aids rescue tea作者: 搖晃 時間: 2025-3-30 02:27 作者: Blasphemy 時間: 2025-3-30 04:59 作者: Accessible 時間: 2025-3-30 11:50 作者: 態學 時間: 2025-3-30 16:01
A Graphical User Interface (GUI) System for a Stationary Trainer Used in Lower Limb Rehabilitationnsion and gait training. In addition to these options, the simulator also enables the user to vary the subject parameters like thigh and crus lengths. The proposed interactive simulator design is demonstrated and verified using computer-based numerical simulations.作者: comely 時間: 2025-3-30 18:20
Identify and Understand the Physical Characteristics that Responsible for the Masculine Nature of a is study can aid the designers in understanding the consumer’s likability or perceptions when they purchase a vehicle. If designers involve this consent while designing any SUVs, it will increase the company’s profit.作者: 四目在模仿 時間: 2025-3-31 00:32 作者: 違反 時間: 2025-3-31 02:46 作者: Boycott 時間: 2025-3-31 05:56
Design and Development of Seed Drill Attachment to Tractor-Drawn Cultivatorctured and evaluated by conducting trails on it and readings are tabulated. Analyzing readings it is suggested that, to obtain an optimum seed rate of 86?kg/ha using seed drill, the tractor has to be run at the speed range of 4–6?km/h.作者: libertine 時間: 2025-3-31 10:37
Design of Snake Robot with 28015 PING Ultrasonic Distance Sensor and Arduinoa barrier in front of the robot and, if so, measures its distance. Analyzing this distance with the directions already coded in the central unit, the snake robot decides the direction to continue the movement. This design can prove beneficial in many real-life problems and can be further improvised by coupling with other technologies.作者: 鍍金 時間: 2025-3-31 14:02
