標題: Titlebook: Electronics Testing and Measurement; William F. Waller Textbook 1972Latest edition Macmillan Publishers Limited 1972 electronics.measureme [打印本頁] 作者: Weber-test 時間: 2025-3-21 17:19
書目名稱Electronics Testing and Measurement影響因子(影響力)
書目名稱Electronics Testing and Measurement影響因子(影響力)學科排名
書目名稱Electronics Testing and Measurement網絡公開度
書目名稱Electronics Testing and Measurement網絡公開度學科排名
書目名稱Electronics Testing and Measurement被引頻次
書目名稱Electronics Testing and Measurement被引頻次學科排名
書目名稱Electronics Testing and Measurement年度引用
書目名稱Electronics Testing and Measurement年度引用學科排名
書目名稱Electronics Testing and Measurement讀者反饋
書目名稱Electronics Testing and Measurement讀者反饋學科排名
作者: 一小塊 時間: 2025-3-22 00:08 作者: 黃油沒有 時間: 2025-3-22 02:35 作者: 致敬 時間: 2025-3-22 08:16 作者: 寬宏大量 時間: 2025-3-22 10:25 作者: 裂縫 時間: 2025-3-22 16:54 作者: 裂縫 時間: 2025-3-22 19:28
Relays and Switches, to be checked. Obviously in order to determine the important aspects of any test procedure, the use to which the device is to be put needs to be known, and the function of it must be understood. The following list is representative of the types of relay which occur in normal use.作者: Circumscribe 時間: 2025-3-22 21:37 作者: 圓柱 時間: 2025-3-23 04:36 作者: sultry 時間: 2025-3-23 08:47 作者: 圓錐 時間: 2025-3-23 11:30 作者: FOR 時間: 2025-3-23 14:40 作者: assail 時間: 2025-3-23 18:39
Electronic Tubes,e devices, leaving the higher power stages of amplification in transmitters and similar equipment as the only places where vacuum tubes are used in the electronics industry excluding electro-optical devices in both TV cameras and receivers.作者: FAWN 時間: 2025-3-24 00:39
Conventional Bridge Measurements,ame as the volt drop along the bottom arm at the point D if the ratio of Rl to R2 is the same as the ratio of R3 to R4. That is R1/R2 = R3/R4. It follows therefore that if a galvanometer is connected between C and D it will indicate zero current if these conditions are satisfied. That is the bridge is in balance when R1/R2 = R3/R4.作者: 漂亮才會豪華 時間: 2025-3-24 06:13 作者: 宇宙你 時間: 2025-3-24 08:46
Beschaffungs- und Einkaufsmanagement,ut stage saturates when the device operates. ECL is a form of Current Mode Logic which is nonsaturating and so achieves a faster switching speed. MOS transistors can be used with certain advantages in integrated circuits and these form a separate category.作者: 相同 時間: 2025-3-24 14:13 作者: Extemporize 時間: 2025-3-24 17:18 作者: Incumbent 時間: 2025-3-24 22:58
Integrierte Materialwirtschaft und Logistike devices, leaving the higher power stages of amplification in transmitters and similar equipment as the only places where vacuum tubes are used in the electronics industry excluding electro-optical devices in both TV cameras and receivers.作者: foliage 時間: 2025-3-25 00:34
https://doi.org/10.1007/978-3-662-07946-1ame as the volt drop along the bottom arm at the point D if the ratio of Rl to R2 is the same as the ratio of R3 to R4. That is R1/R2 = R3/R4. It follows therefore that if a galvanometer is connected between C and D it will indicate zero current if these conditions are satisfied. That is the bridge is in balance when R1/R2 = R3/R4.作者: 千篇一律 時間: 2025-3-25 04:04
Measurement Of Power,e under test, and indicate the power available. Instruments in the first group of power measuring devices fall into four distinct types. Each type has some special features that will make it suitable or otherwise depending on the particular application. The general characteristics of the four types are as follows.作者: Emg827 時間: 2025-3-25 09:05 作者: 冒煙 時間: 2025-3-25 11:47
Linear Integrated Circuits,discrete components. Designers can seldom afford or achieve complete integration of their circuits into one package, notable exceptions being in the radio receiver industry, where all but the aerial, loudspeaker, tuning and volume controls can be fully integrated.作者: 避開 時間: 2025-3-25 16:54 作者: 震驚 時間: 2025-3-25 21:35 作者: Boycott 時間: 2025-3-26 01:54 作者: 辯論 時間: 2025-3-26 07:24 作者: nitroglycerin 時間: 2025-3-26 11:44 作者: BRIBE 時間: 2025-3-26 15:56 作者: Prostaglandins 時間: 2025-3-26 16:47 作者: 藐視 時間: 2025-3-26 23:04
https://doi.org/10.1007/978-3-663-02068-4As indicated in the previous chapter, the oscilloscope has become a universal tool in all kinds of investigations, and is a window on the world of circuit behaviour. It is appropriate here to define the instrument as being an extremely fast X-Y graph plotter, which displays one input signal versus another signal, or versus time.作者: 推遲 時間: 2025-3-27 02:39 作者: 裝勇敢地做 時間: 2025-3-27 09:10
Wound Components,This chapter will deal with wound components and will acquaint the reader with the basic parameters to be measured, the test methods and instruments used together with the error precautions necessary and tolerances to be expected for each type of wound component considered.作者: 和平主義 時間: 2025-3-27 09:50
Microwave Semiconductors,The frequency range 1 GHz to 40 GHz is commonly referred to as the microwave band. It is the purpose of this chapter to describe briefly three major groups of microwave semiconductors used in radar and communications and to indicate their important parameters together with some of the measurement techniques used for assessment.作者: TOXIN 時間: 2025-3-27 14:56 作者: 投射 時間: 2025-3-27 20:37 作者: 延期 時間: 2025-3-27 22:38 作者: 600 時間: 2025-3-28 02:36 作者: 氣候 時間: 2025-3-28 10:09
Oscilloscope Techniques,As indicated in the previous chapter, the oscilloscope has become a universal tool in all kinds of investigations, and is a window on the world of circuit behaviour. It is appropriate here to define the instrument as being an extremely fast X-Y graph plotter, which displays one input signal versus another signal, or versus time.作者: 領導權 時間: 2025-3-28 13:10
Macmillan Publishers Limited 1972作者: 甜得發膩 時間: 2025-3-28 18:03
Anpassung der Balanced Scorecardly what constitutes a general purpose device but these devices have been selected as being most commonly used: bipolar transistors, small signal diodes and zener diodes. Since technology is advancing so rapidly it is now necessary to include integrated circuits of both digital and linear types.作者: 蘆筍 時間: 2025-3-28 21:50 作者: 表示問 時間: 2025-3-29 01:40
Integrierte Materialwirtschaft und Logistik to be checked. Obviously in order to determine the important aspects of any test procedure, the use to which the device is to be put needs to be known, and the function of it must be understood. The following list is representative of the types of relay which occur in normal use.作者: 輪流 時間: 2025-3-29 04:21 作者: 充氣球 時間: 2025-3-29 07:28 作者: 闖入 時間: 2025-3-29 12:51
General Purpose Semiconductors,ly what constitutes a general purpose device but these devices have been selected as being most commonly used: bipolar transistors, small signal diodes and zener diodes. Since technology is advancing so rapidly it is now necessary to include integrated circuits of both digital and linear types.作者: Malaise 時間: 2025-3-29 17:56
Power Semiconductors,stomer receives them. It is essential that these tests are understood before discussing any tests that semiconductor users may apply. The nomenclature and symbols used in the test are those given in BS9300:1969作者: 愚蠢人 時間: 2025-3-29 23:43 作者: Evacuate 時間: 2025-3-30 02:14 作者: 監禁 時間: 2025-3-30 08:07
Making Impedance Measurements,ssential is to know the basic method of measurement employed. Reference to the handbook is always worthwhile before using an unfamiliar instrument. There are many forms of impedance measuring bridges and in this chapter the general principles will be discussed and some common pitfalls examined.作者: 震驚 時間: 2025-3-30 08:18
https://doi.org/10.1007/978-3-662-48667-2 cases the equipment used has been purpose built and in consequence is not available to the average user. In consequence many engineers find themselves in the position of using components which they are not able to adequately test or specify. The test methods described in this chapter are generally 作者: Myofibrils 時間: 2025-3-30 15:04 作者: 輕率看法 時間: 2025-3-30 19:37 作者: phlegm 時間: 2025-3-30 20:56 作者: 結合 時間: 2025-3-31 01:59 作者: 飛來飛去真休 時間: 2025-3-31 08:50 作者: –吃 時間: 2025-3-31 09:24 作者: stress-response 時間: 2025-3-31 15:35 作者: 審問,審訊 時間: 2025-3-31 18:51
https://doi.org/10.1007/978-3-662-07946-1shown in Fig.l. It is easy to see that if a voltage is applied to the points A & B that the volt drop along the upper arm at the point C will be the same as the volt drop along the bottom arm at the point D if the ratio of Rl to R2 is the same as the ratio of R3 to R4. That is R1/R2 = R3/R4. It foll作者: 騎師 時間: 2025-3-31 22:01
Walther Eversheim,Günther Schuh,Dirk Assmusssential is to know the basic method of measurement employed. Reference to the handbook is always worthwhile before using an unfamiliar instrument. There are many forms of impedance measuring bridges and in this chapter the general principles will be discussed and some common pitfalls examined.作者: 解凍 時間: 2025-4-1 02:16
Interview Francotyp Postalia GmbH, Berlin other parameters. These instruments can be divided into two general groups; those that are true power measuring instruments, that is, they indicate the power dissipated in the device under test, and a second group which are absorption meters that dissipate the power in the instrument from the sourc作者: 旅行路線 時間: 2025-4-1 09:19
