標題: Titlebook: Drying of Polymeric and Solid Materials; Modelling and Indust Jean-Maurice Vergnaud Book 1992 Springer-Verlag London Limited 1992 Diffusion [打印本頁] 作者: 愚蠢地活 時間: 2025-3-21 19:00
書目名稱Drying of Polymeric and Solid Materials影響因子(影響力)
書目名稱Drying of Polymeric and Solid Materials影響因子(影響力)學科排名
書目名稱Drying of Polymeric and Solid Materials網絡公開度
書目名稱Drying of Polymeric and Solid Materials網絡公開度學科排名
書目名稱Drying of Polymeric and Solid Materials被引頻次
書目名稱Drying of Polymeric and Solid Materials被引頻次學科排名
書目名稱Drying of Polymeric and Solid Materials年度引用
書目名稱Drying of Polymeric and Solid Materials年度引用學科排名
書目名稱Drying of Polymeric and Solid Materials讀者反饋
書目名稱Drying of Polymeric and Solid Materials讀者反饋學科排名
作者: Embolic-Stroke 時間: 2025-3-21 21:40 作者: 審問 時間: 2025-3-22 02:16
The Law of the Excluded Middle: A Digression composition of epoxy resins, and on the process of cure. Because of the low thermal conductivity of the resin associated with the high exothermicity of the cure reactions, the process gives rise to a high temperature within the resin. These facts are of concern for thick samples, being responsible 作者: 斜 時間: 2025-3-22 06:28
Basic Behavioural and Device Modelst-order reaction. With an oral form, the drug is usually very rapidly liberated, quickly builds up to a high concentration in the stomach, and then falls exponentially until the next dose. As a result, there is an undulating concentration pattern of the drug in the blood and tissues, in which high c作者: defile 時間: 2025-3-22 12:39
Basic Behavioural and Device Modelsrinkage of this polymer is thus observed during the process of desorption. The process is controlled by transient diffusion of the liquid within the polymer and evaporation from the surface. To obtain analytical solutions the mathematical treatment neglects the change in the dimensions of the polyme作者: follicle 時間: 2025-3-22 14:23
https://doi.org/10.1007/978-1-4471-1954-8Diffusion/Evaporation; Drying; Numerical modelling; Polymers; atmosphere; experiment; kinetics; membrane; nu作者: follicle 時間: 2025-3-22 19:36 作者: STING 時間: 2025-3-22 22:42 作者: Chandelier 時間: 2025-3-23 01:44
Scotland,Various cases of one-dimensional diffusion in a solid bounded by two parallel planes, with evaporation on the surfaces, are considered. The plane sheet is so thin that all the liquid evaporates through the plane surfaces and a negligible amount through the edges, and the diffusivity . is constant.作者: NIL 時間: 2025-3-23 06:51
Wales,Various cases of diffusion with constant diffusivity in cylinders are considered, when:作者: 死亡 時間: 2025-3-23 13:41
Scotland,The following cases of diffusion-evaporation for a solid sphere with radial transfer and constant diffusivity, are of interest. The initial concentration within the sphere is considered uniform:作者: BRAND 時間: 2025-3-23 16:15 作者: Confirm 時間: 2025-3-23 20:17 作者: Monotonous 時間: 2025-3-24 01:17 作者: 兩棲動物 時間: 2025-3-24 04:01 作者: Aggrandize 時間: 2025-3-24 09:24
The Law of the Excluded Middle: A DigressionTesting of rubber materials involves exposure to various types of environmental factors: temperature, which plays a part in all environment tests, moisture, steam, liquids and gases.作者: filial 時間: 2025-3-24 11:54
The Law of the Excluded Middle: A DigressionThe process of drying of plasticised PVC appears to be strange at first, but it can be explained by the formation of steep gradients of concentration which play a important role when the diffusivity is concentration dependent.作者: Pde5-Inhibitors 時間: 2025-3-24 18:33 作者: 背心 時間: 2025-3-24 21:20
Principles and General Equations,The general problem of the drying of solids can be complex as three types of transport exist for liquid and vapour (Fig. 1.1):作者: 褲子 時間: 2025-3-25 02:26
Thin Plane Sheet,Various cases of one-dimensional diffusion in a solid bounded by two parallel planes, with evaporation on the surfaces, are considered. The plane sheet is so thin that all the liquid evaporates through the plane surfaces and a negligible amount through the edges, and the diffusivity . is constant.作者: Mast-Cell 時間: 2025-3-25 05:32
Cylinder,Various cases of diffusion with constant diffusivity in cylinders are considered, when:作者: OCTO 時間: 2025-3-25 08:13 作者: Ophthalmologist 時間: 2025-3-25 14:32 作者: 圓錐體 時間: 2025-3-25 16:58
Numerical Analysis for a Cylinder,Many problems appear with cylinders because various kinds of cylinders are encountered. Moreover, interesting applications are drawn either from solid cylinders or from hollow cylinders, with infinite or finite length in both cases.作者: 令人作嘔 時間: 2025-3-25 23:28
Diffusion-Evaporation in Two and Three Dimensions: Isotropic and Anisotropic Media,The process of drying of media having two or three dimensions is of great interest, and numerical models can be successfully applied to these various applications.作者: OWL 時間: 2025-3-26 02:33
Drying of Wet Earth for Adobe Construction,Primitive adobe dwellings constructed from thick walls of crude earth (clay) still predominate in poor or developing countries where bricks and concrete are not produced. This type of earth wall is very inexpensive, but it does not perform very well because of its poor mechanical properties.作者: 陰謀 時間: 2025-3-26 05:36
Drying of Rubbers,Testing of rubber materials involves exposure to various types of environmental factors: temperature, which plays a part in all environment tests, moisture, steam, liquids and gases.作者: RACE 時間: 2025-3-26 08:45 作者: 揭穿真相 時間: 2025-3-26 14:55
Drying of Wood,Wood is continually exchanging moisture and this phenomenon is observed not only for living trees but also for pieces of wood in use, whatever the surrounding atmosphere. This surrounding atmosphere can be air or water, and in all these cases, the problem of drying the pieces of wood is of interest.作者: 一再困擾 時間: 2025-3-26 18:39 作者: minion 時間: 2025-3-26 23:50 作者: Admonish 時間: 2025-3-27 01:42 作者: Diskectomy 時間: 2025-3-27 05:38
Numerical Analysis for a Sphere,ns of materials in powder form are very often considered as spherical, and when the shape of the grain is not known, the radius of a sphere having the same volume as that of the grain is sometimes used.作者: 世俗 時間: 2025-3-27 12:50 作者: transdermal 時間: 2025-3-27 15:55 作者: 攀登 時間: 2025-3-27 21:25 作者: Nibble 時間: 2025-3-28 01:08 作者: 傾聽 時間: 2025-3-28 03:25
umerical models with experiments. The main advantages of this method are a significant saving of time and money. Numerical modelling can predict the kinetics of drying and the profiles of liquid concentration through the solid. This helps in the selection of optimal operational conditions. The simul作者: glamor 時間: 2025-3-28 07:57 作者: precede 時間: 2025-3-28 14:28 作者: engrossed 時間: 2025-3-28 18:31
Basic Behavioural and Device Modelslls exponentially until the next dose. As a result, there is an undulating concentration pattern of the drug in the blood and tissues, in which high concentration alternates with low concentration. The optimal therapeutic level is only briefly present in this case.作者: eulogize 時間: 2025-3-28 19:50 作者: 要素 時間: 2025-3-29 00:51
Book 1992odels with experiments. The main advantages of this method are a significant saving of time and money. Numerical modelling can predict the kinetics of drying and the profiles of liquid concentration through the solid. This helps in the selection of optimal operational conditions. The simulation of t作者: 乞討 時間: 2025-3-29 06:36
Drying of Paints, various steps involved, and thus enabling the prediction of the time necessary to dry the coating with a given thickness and solvent concentration. Another purpose is to gain a fuller understanding of the process when the paint is composed not only of one layer but of several superimposed layers.作者: 領袖氣質 時間: 2025-3-29 10:06
Drying of Thermosetting Coatings,of the cure reactions, the process gives rise to a high temperature within the resin. These facts are of concern for thick samples, being responsible for discoloration or degradation of the final material, cracking or crazing, or even distortion of the moulding [1–4].作者: AVOID 時間: 2025-3-29 12:43 作者: 樸素 時間: 2025-3-29 16:08 作者: airborne 時間: 2025-3-29 20:25
Book 1992 drying and the profiles of liquid concentration through the solid. This helps in the selection of optimal operational conditions. The simulation of the process is also crucial in the assessment of diffusity and the rate of evaporation.作者: 喧鬧 時間: 2025-3-30 00:41 作者: 套索 時間: 2025-3-30 05:00 作者: effrontery 時間: 2025-3-30 11:18
Margit Schratzenstallerussierung der Innenperspektive um direkt im Erleben der betroffenen Personen repr?sentierte kognitive Schemata, die Murray — zu einem Zeitpunkt, als die ?kognitive Wende“ der Psychologie noch nicht offiziell proklamiert worden war — als ?β-press-Variablen“ bezeichnet hatte.作者: insightful 時間: 2025-3-30 14:31 作者: Melodrama 時間: 2025-3-30 19:36 作者: vasculitis 時間: 2025-3-30 22:08 作者: RACE 時間: 2025-3-31 01:52
Textbook 2023Latest edition werden komplexe Zahlen, Vektoren und Matrizen, Taylor-Reihen, gew?hnliche Differenzialgleichungen, Fourier-Reihen, partielle Ableitungen und Elemente der Vektoranalysis behandelt. Ebenso finden Sie in diesem Buch eine Untersuchung elementarer Erhaltungss?tze als auch deren Anwendung auf physikalisc
