作者: Glutinous 時間: 2025-3-21 21:37
Direct-Contact Heat Transfer in Solid-Gas Systems,in depth. We are essentially considering the state of knowledge and continuing needs for describing the exchange between a gas and solids—either particles, solid boundaries, or both-when there are temperature differences between the media.作者: CRUC 時間: 2025-3-22 02:20
Direct-Contact Condensation, the processes and points out the uncertainties related to our knowledge of the basic mechanisms. In doing so, it points out the needed additional research that should be carried out in order to optimize the design of engineering equipment based upon the various condensation processes.作者: Bernstein-test 時間: 2025-3-22 07:07 作者: Aggrandize 時間: 2025-3-22 11:30 作者: thyroid-hormone 時間: 2025-3-22 14:10
Conference proceedings 1988nergy Research Insti- tute in the summer of 1985. We served as organizers for this workshop, which em- phasized an area of thermal engineering that, in our opinion, has great promise for the future, but has not yet reached the point of wide-spread commercial application. Hence, a summary of the stat作者: thyroid-hormone 時間: 2025-3-22 18:45
Conference proceedings 1988al practi- tioners can make use of the available information. 2. To indicate the research and development needed to advance the state-of-the-art, indicating not only what kind of research is needed, but also the industrial poten- tial that could be realized if the information to be obtained through the proposed research activities were available.作者: 嬉耍 時間: 2025-3-22 21:46
https://doi.org/10.1007/978-3-662-59127-7lications, thermal stress and corrosion problems are imposed on the wall materials themselves. These situations are present irrespective of whether the two fluid streams are solid, liquid, vapor, gaseous, or some mixtures of them.作者: 考博 時間: 2025-3-23 02:06 作者: 軍械庫 時間: 2025-3-23 06:44 作者: 去掉 時間: 2025-3-23 12:07 作者: 外面 時間: 2025-3-23 16:08
Solids Motion and Heat Transfer in Gas Fluidized Beds,solids and immersed surfaces, permitting direct heat removal at low temperature drop using immersed heat-exchange tubes. Fluidized beds are also used in various configurations as heat exchangers. These and many other applications can be found in standard references (Kunii and Levenspiel, 1969; Davidson and Harrison, 1971; Kunii and Toei, 1983).作者: Vsd168 時間: 2025-3-23 19:10 作者: 高度表 時間: 2025-3-23 23:46
he Solar Energy Research Insti- tute in the summer of 1985. We served as organizers for this workshop, which em- phasized an area of thermal engineering that, in our opinion, has great promise for the future, but has not yet reached the point of wide-spread commercial application. Hence, a summary o作者: ostensible 時間: 2025-3-24 05:29 作者: Herd-Immunity 時間: 2025-3-24 10:23
Industrial Practices and Two-Phase Transport,rocess design because they have little knowledge of it. Emphasis was on gas-liquid contactors; design equations with and without heat transfer were presented. Major problems associated with using direct-contact heat transfer in the process industries are作者: Recessive 時間: 2025-3-24 12:26
Mass Transfer Effects in Heat Transfer Processes,nd gas adsorption are examples. Gas-liquid, liquid-liquid, or fluid-solid systems are passed through devices such as packed towers, plate towers, fixed or fluidized beds, spray, and bubble towers designed to promote physical contact of the phases.作者: 得罪 時間: 2025-3-24 17:02 作者: MUTE 時間: 2025-3-24 21:00
Direct-Contact Evaporation,cient speed to break through the interfacial surface tension; i. e., they possess kinetic energy exceeding the work function of cohesion at the surface. Since only a small portion of the molecules is at any instant located near enough to the surface and moving in the proper direction to escape, the rate of evaporation is limited.作者: Arctic 時間: 2025-3-25 03:11
http://image.papertrans.cn/e/image/280653.jpg作者: immunity 時間: 2025-3-25 04:50 作者: phase-2-enzyme 時間: 2025-3-25 10:39
https://doi.org/10.1007/978-3-662-59127-7In the design of an industrial liquid-liquid process the decisions concern selection of the contacting phase, a solvent or a working fluid, and the type of contactor, its size and range of operating conditions.作者: 合并 時間: 2025-3-25 12:44 作者: Gentry 時間: 2025-3-25 17:29 作者: 帶傷害 時間: 2025-3-25 21:36 作者: 群島 時間: 2025-3-26 03:35 作者: 鳴叫 時間: 2025-3-26 05:53 作者: Lament 時間: 2025-3-26 09:03 作者: 免費 時間: 2025-3-26 13:16 作者: bifurcate 時間: 2025-3-26 18:30 作者: NAVEN 時間: 2025-3-26 20:59
Springer Lexikon Kosmetik und K?rperpflegeocesses and simultaneous direct-contact heat and mass transfer. This task was greatly facilitated by the review papers by Perona [1] and Letan [2], which provided the necessary guidance for the discussion.作者: resuscitation 時間: 2025-3-27 04:50
Springer Lexikon Kosmetik und K?rperpflegecient speed to break through the interfacial surface tension; i. e., they possess kinetic energy exceeding the work function of cohesion at the surface. Since only a small portion of the molecules is at any instant located near enough to the surface and moving in the proper direction to escape, the rate of evaporation is limited.作者: cultivated 時間: 2025-3-27 09:16
https://doi.org/10.1007/978-3-662-30182-1development; energy; flow; heat; heat transfer; information; solar; solar energy作者: 輕快帶來危險 時間: 2025-3-27 11:04 作者: colostrum 時間: 2025-3-27 14:10
https://doi.org/10.1007/978-3-662-59127-7m thermodynamic potential of the system’s heat source. In classical heat exchangers, heat transfer takes place through a wall separating the hot and the cold fluid streams. Thus, conventional heat exchangers are limited in their ability to tap the maximum thermodynamic potential because they have bu作者: ROOF 時間: 2025-3-27 21:21 作者: 填料 時間: 2025-3-28 01:30
https://doi.org/10.1007/978-3-662-59127-7rocess design because they have little knowledge of it. Emphasis was on gas-liquid contactors; design equations with and without heat transfer were presented. Major problems associated with using direct-contact heat transfer in the process industries are作者: BATE 時間: 2025-3-28 05:59 作者: 懸掛 時間: 2025-3-28 06:47 作者: 丑惡 時間: 2025-3-28 11:25
https://doi.org/10.1007/978-3-662-59127-7 fluid-like in a number of respects and is said to be fluidized. Because of the very large surface area, heat and mass exchange between the fluid and the solids are extremely efficient. In the case of typical gas fluidized beds, the solids also possess large mean and fluctuating velocities, thus pro作者: 得意牛 時間: 2025-3-28 18:23 作者: 苦笑 時間: 2025-3-28 21:42
https://doi.org/10.1007/978-3-540-71095-0 phenomenon was the principal application of this direct-contact process for many years and may remain so today. The thrust of the current workshop has been the examination of fundamental heat transfer phenomena, however, so the situation with chemically reacting species will not be considered here 作者: Narcissist 時間: 2025-3-29 00:15
Springer Lexikon Kosmetik und K?rperpflegecient speed to break through the interfacial surface tension; i. e., they possess kinetic energy exceeding the work function of cohesion at the surface. Since only a small portion of the molecules is at any instant located near enough to the surface and moving in the proper direction to escape, the 作者: 乳白光 時間: 2025-3-29 04:47
Springer Lexikon Kosmetik und K?rperpflege and “bubble type” and classifies typical equipment that falls under the classifications. Next, it reviews the current state of our ability to analyze the processes and points out the uncertainties related to our knowledge of the basic mechanisms. In doing so, it points out the needed additional res作者: burnish 時間: 2025-3-29 11:11 作者: 原始 時間: 2025-3-29 12:00 作者: myalgia 時間: 2025-3-29 17:54 作者: rectocele 時間: 2025-3-29 22:56
Mass Transfer Effects in Heat Transfer Processes,nd gas adsorption are examples. Gas-liquid, liquid-liquid, or fluid-solid systems are passed through devices such as packed towers, plate towers, fixed or fluidized beds, spray, and bubble towers designed to promote physical contact of the phases.作者: negotiable 時間: 2025-3-30 00:45 作者: 鑲嵌細工 時間: 2025-3-30 06:29
Solids Motion and Heat Transfer in Gas Fluidized Beds, fluid-like in a number of respects and is said to be fluidized. Because of the very large surface area, heat and mass exchange between the fluid and the solids are extremely efficient. In the case of typical gas fluidized beds, the solids also possess large mean and fluctuating velocities, thus pro作者: 鎮痛劑 時間: 2025-3-30 10:30
High-Temperature Solids-Gas Interactions,rations are covered: fluidized bed, entrained flow, and free-falling particle flow. Several preliminary experimental studies have been conducted using each of these flow configurations. These are discussed and comparisons between them are made. Some theoretical modeling of the radiative transport an
