標題: Titlebook: Compensation Systems for Low Temperature Applications; B?a?ej T. Skoczeń Book 2004 Springer-Verlag Berlin Heidelberg 2004 Constitutive Equ [打印本頁] 作者: IU421 時間: 2025-3-21 17:37
書目名稱Compensation Systems for Low Temperature Applications影響因子(影響力)
書目名稱Compensation Systems for Low Temperature Applications影響因子(影響力)學科排名
書目名稱Compensation Systems for Low Temperature Applications網(wǎng)絡公開度
書目名稱Compensation Systems for Low Temperature Applications網(wǎng)絡公開度學科排名
書目名稱Compensation Systems for Low Temperature Applications被引頻次
書目名稱Compensation Systems for Low Temperature Applications被引頻次學科排名
書目名稱Compensation Systems for Low Temperature Applications年度引用
書目名稱Compensation Systems for Low Temperature Applications年度引用學科排名
書目名稱Compensation Systems for Low Temperature Applications讀者反饋
書目名稱Compensation Systems for Low Temperature Applications讀者反饋學科排名
作者: figment 時間: 2025-3-21 20:27 作者: COW 時間: 2025-3-22 00:44
Properties of Austenitic Stainless Steels at Cryogenic Temperatures,nd 321 were used for low temperature service, however the recent studies show their rather limited applicability. An important feature of the above mentioned stainless steel grades is the presence of large amount of chromium reaching some 16 ÷ 20% as well as reduced amount of carbon of around 0.030.作者: dysphagia 時間: 2025-3-22 04:41 作者: Hay-Fever 時間: 2025-3-22 09:31 作者: medieval 時間: 2025-3-22 13:44 作者: medieval 時間: 2025-3-22 19:37 作者: judiciousness 時間: 2025-3-23 01:13
Reliability Oriented Optimum Design Of Cryogenic Compensation Systems, et al. 1997). A poor reliability of a group of components may yield a sequence of failures that will make smooth operation of the system impossible. Thus, an investment in the reliability oriented optimum design may reduce considerably the number and the total cost of repairs and interventions asso作者: PATRI 時間: 2025-3-23 03:46
Applications: Accelerators for High Energy Physics and Cryogenics Transfer Lines,r. One of the most important aims over the past 30 years was confirmation of the so-called Standard Model which assumes that the fundamental constituents of matter form three families of quarks and leptons. The relevant scientific tools are called accelerators, storage rings and colliders and their 作者: 慢慢沖刷 時間: 2025-3-23 09:24
Book 2004ure complex) installation for testing at such low temperatures is very expensive. Only the large research centres and universities, working in the domain of superconductivity, cryogen- ics or developing superconducting magnets for particle accelerators, can afford such installations. A significant p作者: 植物學 時間: 2025-3-23 10:37
Zehavit Gross,Suzanne D. Rutlandn the domain of particle accelerators where a continuity of the magnetic field is strongly postulated by the accelerator physics. On the other hand, the real structure has to be discontinuous, since the magnets are limited in length (for technological reasons) and separated by the so-called intercon作者: 慟哭 時間: 2025-3-23 15:43 作者: Amorous 時間: 2025-3-23 19:33
Zehavit Gross,Suzanne D. Rutlandnd 2%), Mo (up to 3%), S (around 0.03%) and P (around 0.05%). In the grades 316Ti, 321 titanium is present to the upper limit of 0.7%. Composition of typical grades of wrought stainless steel for low temperature use is shown in Table 3.1 (as quoted in the ASTM and ASME specifications, cf. INGO Datab作者: 惡心 時間: 2025-3-24 00:10
Tongying Guo,Hui Zhang,Lincang Zhu a classical .-phase of face centred cubic austenite (FCC). This phase may transform either to .′ phase of body centred tetragonal ferrite (BCT) or to a hexagonal . phase. The most often occurring . — .′ transformation leads to formation of martensite sites dispersed in the surrounding austenite mat作者: 的闡明 時間: 2025-3-24 03:50
https://doi.org/10.1007/978-981-10-5308-5ed energy per beam was obtained by smooth accelerating of particles during many turns around the ring. The beams were accelerated by means of the so-called accelerating cavities, kept on their trajectory by using the bending dipole magnets, were focalised and defocalised by means of the quadrupole m作者: epidermis 時間: 2025-3-24 07:56
Compensation Systems for Low Temperature Applications作者: Physiatrist 時間: 2025-3-24 11:23 作者: 盡忠 時間: 2025-3-24 16:30
large research centres and universities, working in the domain of superconductivity, cryogen- ics or developing superconducting magnets for particle accelerators, can afford such installations. A significant p978-3-642-06066-3978-3-662-06305-7作者: Fissure 時間: 2025-3-24 21:13 作者: 正式通知 時間: 2025-3-25 00:26
Thermodynamics of Processes Occurring in Metals at Low Temperatures,tance for the existence and triggering of special mechanisms of inelastic deformation like the shear bands. When analysing the response of thin-walled structures at low temperatures all these phenomena have to be taken into account.作者: 擴張 時間: 2025-3-25 04:36
Properties of Austenitic Stainless Steels at Cryogenic Temperatures,nd 2%), Mo (up to 3%), S (around 0.03%) and P (around 0.05%). In the grades 316Ti, 321 titanium is present to the upper limit of 0.7%. Composition of typical grades of wrought stainless steel for low temperature use is shown in Table 3.1 (as quoted in the ASTM and ASME specifications, cf. INGO Datab作者: strdulate 時間: 2025-3-25 10:03
Strain Induced Martensitic Transformation at Low Temperatures, a classical .-phase of face centred cubic austenite (FCC). This phase may transform either to .′ phase of body centred tetragonal ferrite (BCT) or to a hexagonal . phase. The most often occurring . — .′ transformation leads to formation of martensite sites dispersed in the surrounding austenite mat作者: inferno 時間: 2025-3-25 14:39
Applications: Accelerators for High Energy Physics and Cryogenics Transfer Lines,ed energy per beam was obtained by smooth accelerating of particles during many turns around the ring. The beams were accelerated by means of the so-called accelerating cavities, kept on their trajectory by using the bending dipole magnets, were focalised and defocalised by means of the quadrupole m作者: arbovirus 時間: 2025-3-25 18:29 作者: Senescent 時間: 2025-3-25 23:15 作者: 陶瓷 時間: 2025-3-26 00:49 作者: 原始 時間: 2025-3-26 06:23
Material and Fatigue Induced Structural Instabilities of Corrugated Bellows at Low Temperatures,e the process of opening of micro-cracks and micro-voids shifting simultaneously deformations towards the elastic domain (considerable increase of yield strength). Nevertheless, the behaviour of corrugated bellows, highly optimised with respect to their size and stiffness, is affected by the low cycle fatigue phenomena.作者: dragon 時間: 2025-3-26 10:38 作者: Fsh238 時間: 2025-3-26 13:49
perconducting particle accelerators, spacecrafts.Includes suThe present monograph is mainly focused on the behaviour of ductile ma- terials at cryogenic temperatures, stability issues concerning application of corrugated shells at cryogenic conditions and reliability oriented parametric optimisation作者: anaphylaxis 時間: 2025-3-26 16:53
Zehavit Gross,Suzanne D. Rutlandver 1998) or coolant transfer lines (Lebrun 1999a) as well as small scale refrigerators and cryo-coolers generate significant progress in multiple domains related either to material sciences or to structural behaviour. When designing large scale cryogenic systems the engineers quickly realise that i作者: Phenothiazines 時間: 2025-3-26 21:57
Zehavit Gross,Suzanne D. Rutlandd its imperfections as well as to the mechanisms of heat transport. The basic mechanism of inelastic deformations remains the same and is based on the motion of dislocations. However, as the Peierls-Nabarro potential increases at low temperature, the dislocations are less mobile. Thus, the same load作者: 誘使 時間: 2025-3-27 04:16
Zehavit Gross,Suzanne D. Rutlandnd 321 were used for low temperature service, however the recent studies show their rather limited applicability. An important feature of the above mentioned stainless steel grades is the presence of large amount of chromium reaching some 16 ÷ 20% as well as reduced amount of carbon of around 0.030.作者: llibretto 時間: 2025-3-27 06:57 作者: acetylcholine 時間: 2025-3-27 11:43
Tongying Guo,Hui Zhang,Lincang Zhud cryogenic transfer lines since they retain their ductility at low temperatures and are paramagnetic. The nitrogen strengthened stainless steels of series 300 belong to the group of metastable austenitic alloys. Under certain conditions the steels undergo martensitic transformation at cryogenic tem作者: 上坡 時間: 2025-3-27 16:34 作者: 合法 時間: 2025-3-27 20:58 作者: META 時間: 2025-3-27 22:23
Combination of Wire Loop and Screw, et al. 1997). A poor reliability of a group of components may yield a sequence of failures that will make smooth operation of the system impossible. Thus, an investment in the reliability oriented optimum design may reduce considerably the number and the total cost of repairs and interventions asso作者: Phagocytes 時間: 2025-3-28 04:35
https://doi.org/10.1007/978-981-10-5308-5r. One of the most important aims over the past 30 years was confirmation of the so-called Standard Model which assumes that the fundamental constituents of matter form three families of quarks and leptons. The relevant scientific tools are called accelerators, storage rings and colliders and their 作者: 委屈 時間: 2025-3-28 07:33
B?a?ej T. SkoczeńOnly book dealing with material and structural stability issues at cryogenic temperatures.Fundamental to cooling systems, transfer lines, superconducting particle accelerators, spacecrafts.Includes su作者: BILK 時間: 2025-3-28 10:57 作者: gratify 時間: 2025-3-28 16:56
Stability of Corrugated Axisymmetric Shells (Bellows),exible Euler’s column and the mode of buckling corresponds to the column mode. Such a response can be modelled by using a slender pressurised thin-walled tube (Haringx 1952). This equivalent tube subjected to inner pressure and supported at the extremities buckles again like a column subjected to axial stress (Fig. 6.1).作者: 祝賀 時間: 2025-3-28 20:48 作者: Decibel 時間: 2025-3-29 00:33 作者: 吞沒 時間: 2025-3-29 03:26 作者: Precursor 時間: 2025-3-29 08:25
