標題: Titlebook: Challenges in Mechanics of Time Dependent Materials, Volume 2; Proceedings of the 2 Alex Arzoumanidis,Meredith Silberstein,Alireza Ami Conf [打印本頁] 作者: 矜持 時間: 2025-3-21 17:16
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2影響因子(影響力)
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2影響因子(影響力)學科排名
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2網(wǎng)絡公開度
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2網(wǎng)絡公開度學科排名
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2被引頻次
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2被引頻次學科排名
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2年度引用
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2年度引用學科排名
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2讀者反饋
書目名稱Challenges in Mechanics of Time Dependent Materials, Volume 2讀者反饋學科排名
作者: Detonate 時間: 2025-3-21 22:09 作者: Needlework 時間: 2025-3-22 02:46
https://doi.org/10.1007/978-3-658-15971-9asurements and quasi-static uniaxial compression to form satisfactory master curves, and these data are compared with those from PBX 9501. A unique inhomogeneity is observed in the LX-14 compression data as a function of the specimen location.作者: 易達到 時間: 2025-3-22 05:48
https://doi.org/10.1007/978-3-658-15971-9FRPs are predicted statistically using the statistical static strengths at various temperatures. Finally, the creep failure times of these unidirectional CFRPs are measured experimentally using these unidirectional CFRPs for comparison with the predicted ones.作者: MURKY 時間: 2025-3-22 09:18 作者: sparse 時間: 2025-3-22 12:58
Influence of FH on a GSM System, making it capable to predict onset of tertiary creep failure. Test results show a correlation between measured continuous stiffness response and creep damage with the capability to predict the onset of tertiary stage.作者: sparse 時間: 2025-3-22 18:19
Influence of FH on a GSM System,uding: repeatability, controlled failure, safe experiments, assessment of loading path dependence, experimental efficiency and overall facility. The experimental design and development are described along with resulting measurements and findings from sample experiments.作者: FRET 時間: 2025-3-23 00:15
Coupled Anisothermal Chemomechanical Degradation Solutions in One Dimension,red: expansion due to chemical reaction, change in solid density from unreacted to fully-oxidized material, interactive force among constituents, and stress variation across reaction zone. The method presented considers the anisothermal evolution of the problem.作者: 路標 時間: 2025-3-23 01:41 作者: 血統(tǒng) 時間: 2025-3-23 07:54
Statistical Life Time Prediction Under Tension Loading for Unidirectional CFRP with Thermoplastics FRPs are predicted statistically using the statistical static strengths at various temperatures. Finally, the creep failure times of these unidirectional CFRPs are measured experimentally using these unidirectional CFRPs for comparison with the predicted ones.作者: 薄膜 時間: 2025-3-23 11:40
Time and Temperature Dependence on Tensile Strength of Unidirectional CFRP with Various Carbon Fibeconstant load and a temperature are measured experimentally and probabilistically using these CFRP strands for comparison with the predicted ones. Additionally, the predicting method is also applied to two kinds of CFRP strands with two kinds of pitch based carbon fibers.作者: 調味品 時間: 2025-3-23 15:58
Material Creep Behavior with Prediction of Tertiary Creep Failure by a Spherical Micro-indentation making it capable to predict onset of tertiary creep failure. Test results show a correlation between measured continuous stiffness response and creep damage with the capability to predict the onset of tertiary stage.作者: 猛擊 時間: 2025-3-23 20:23 作者: 策略 時間: 2025-3-24 01:19 作者: Neolithic 時間: 2025-3-24 04:35
Thomas Toftegaard Nielsen,Jeroen Wigardhen reached a plateau with the proceeding of immersion testing; and the studied AZ31 magnesium alloy did not experience significant deterioration of mechanical properties (i.e., yield strength and ultimate compression strength) after it was immersed in simulated body fluid for up to 14?days.作者: Emg827 時間: 2025-3-24 09:19
https://doi.org/10.1007/b118122ers on both the faces. Tests demonstrated that this design could lead to improvement in product performance, designed for acoustics /vibration isolation environment. The design has the flexibility to adapt its characteristics to suit various end application environments.作者: 施舍 時間: 2025-3-24 14:14 作者: decode 時間: 2025-3-24 18:42 作者: 多余 時間: 2025-3-24 21:08
Conference proceedings 2018eneral technical research areas:?.Characterization Across Length Scales.Extreme Environments & Environmental Effects.Viscoelasticity.Structure Function PerformancePolymer Viscoplasticity.Metallic Materials.Fracture/Fatigue/Damage.Composites.Soft Materials.作者: 易改變 時間: 2025-3-25 01:43 作者: grenade 時間: 2025-3-25 03:51
Influence of FH on a GSM System,well springs whose nonlinearity is motivated by MD simulation. Validation experiments will be conducted on PMMA and the results will be compared to Finite Element Analysis. The FEA will include an entropy-based reduced time constitutive model with the nonlinear Maxwell springs.作者: Itinerant 時間: 2025-3-25 08:22 作者: 揉雜 時間: 2025-3-25 14:31 作者: JADED 時間: 2025-3-25 16:19
Conference Proceedings of the Society for Experimental Mechanics Serieshttp://image.papertrans.cn/c/image/223476.jpg作者: 情感脆弱 時間: 2025-3-25 23:55 作者: Assemble 時間: 2025-3-26 02:27 作者: 子女 時間: 2025-3-26 05:31
https://doi.org/10.1007/978-3-319-63393-0Society for Experimental Mechanics Annual Meeting, 2017; Conference proceedings mechanics of time-dep作者: PALMY 時間: 2025-3-26 08:30
978-3-319-87542-2The Society for Experimental Mechanics, Inc. 2018作者: 極大痛苦 時間: 2025-3-26 13:04 作者: 先驅 時間: 2025-3-26 19:33 作者: 不遵守 時間: 2025-3-27 00:07 作者: GUISE 時間: 2025-3-27 01:44
https://doi.org/10.1007/978-3-658-15971-9rectional CFRP from the statistical static strengths of unidirectional CFRP measured at various temperatures. First, a method of predicting the statistical creep failure time of CFRP is explained briefly based on Christensen’s model of viscoelastic crack kinetics. Second, two types of unidirectional作者: PHON 時間: 2025-3-27 06:12
A Brief Introduction to the GSM System, statistical static strengths of this CFRP measured at various temperatures is applied to various unidirectional CFRP with different kinds of carbon fibers. Two kinds of CFRP strands with two kinds of PAN based carbon fibers as specimens for unidirectional CFRP are prepared. The static strengths of 作者: Alpha-Cells 時間: 2025-3-27 12:06
Thomas Toftegaard Nielsen,Jeroen Wigarduirements. However, several cases of premature failures of asphalt roof shingles nominally rated for 150 mph wind speed have been reported for wind speeds significantly below the nominal rating (typical of Category 4 hurricanes). Since asphalt shingle systems can be subjected to hurricane winds that作者: Irrigate 時間: 2025-3-27 15:23
Thomas Toftegaard Nielsen,Jeroen Wigardinteraction energies between constituents, leading to relative displacement-based interactive body forces with associated stiffnesses and densities. A brief discussion of potential couple stresses follows.作者: 拉開這車床 時間: 2025-3-27 21:16 作者: 糾纏 時間: 2025-3-27 23:29
Thomas Toftegaard Nielsen,Jeroen Wigarde immersed/corroded samples were tested under compression to study the effect of immersion processing on mechanical properties of the material. The immersed/corroded sample surfaces were observed using scanning electron microscope. The results show that the degradation started with uniform corrosion作者: cliche 時間: 2025-3-28 02:09 作者: 有常識 時間: 2025-3-28 09:27
Influence of FH on a GSM System,ic loading and typically have difficulty capturing the response after a reversal of the deformation process. In particular, most models pay little attention to capturing the equilibrium stress, the anisotropy developed after plastic flow in the elastic response, and the characteristics of the yield 作者: Brain-Imaging 時間: 2025-3-28 13:43 作者: 恃強凌弱的人 時間: 2025-3-28 15:51 作者: Sinus-Node 時間: 2025-3-28 22:04
Thomas Toftegaard Nielsen,Jeroen Wigard and damage initiation and growth as a result of complex loading (creep and/or fatigue) scenarios and/or environmental attack. The degradation and damage in the material can result in a decrease in load-carrying capability. It is the decrease of capability as a function of time/usage/exposure that m作者: Daily-Value 時間: 2025-3-29 01:16
Challenges in Mechanics of Time Dependent Materials, Volume 2978-3-319-63393-0Series ISSN 2191-5644 Series E-ISSN 2191-5652 作者: 痛苦一生 時間: 2025-3-29 05:34 作者: RUPT 時間: 2025-3-29 07:18 作者: 虛弱 時間: 2025-3-29 13:22
Experimental Characterisation of the Mechanical Properties of the Clay-Rock/Concrete Interfaces andsation of the short-term response of the interface with direct shear tests, long duration shear tests under constant normal load have been performed with a new experimental apparatus which was developed for this study. The response of the interface in time is discussed.作者: Grating 時間: 2025-3-29 18:27 作者: 記成螞蟻 時間: 2025-3-29 23:01
Time-Temperature Analysis, DMA and Compression in PBXs,ture, strain rate and binders. In this work, we have measured and analyzed the mechanical properties of LX-14, which contains 95.5?wt% HMX (octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine) and 4.5?wt% Estane 5702, with no additional plasticizer. We are interested to compare LX-14 with PBX 9501 (95?作者: HPA533 時間: 2025-3-30 01:59
Statistical Life Time Prediction Under Tension Loading for Unidirectional CFRP with Thermoplastics rectional CFRP from the statistical static strengths of unidirectional CFRP measured at various temperatures. First, a method of predicting the statistical creep failure time of CFRP is explained briefly based on Christensen’s model of viscoelastic crack kinetics. Second, two types of unidirectional作者: avulsion 時間: 2025-3-30 07:21
Time and Temperature Dependence on Tensile Strength of Unidirectional CFRP with Various Carbon Fibe statistical static strengths of this CFRP measured at various temperatures is applied to various unidirectional CFRP with different kinds of carbon fibers. Two kinds of CFRP strands with two kinds of PAN based carbon fibers as specimens for unidirectional CFRP are prepared. The static strengths of 作者: 尾隨 時間: 2025-3-30 10:19 作者: deficiency 時間: 2025-3-30 14:02
A Mixture Theory with Interactive Body Forces for Composite Interphases,interaction energies between constituents, leading to relative displacement-based interactive body forces with associated stiffnesses and densities. A brief discussion of potential couple stresses follows.作者: Parabola 時間: 2025-3-30 19:58
Material Creep Behavior with Prediction of Tertiary Creep Failure by a Spherical Micro-indentation at room temperature. Stress exponent values were determined through a constant loading process utilizing a spherical micro indentation method, where the strain rate is extracted from the indentation rate. The measured stress exponent values are in good agreement with conventional creep experiments.作者: 最低點 時間: 2025-3-30 21:53
Mechanical and Biodegradable Behavior of AZ31 Magnesium Alloy Immersed in Simulated Body Fluid,e immersed/corroded samples were tested under compression to study the effect of immersion processing on mechanical properties of the material. The immersed/corroded sample surfaces were observed using scanning electron microscope. The results show that the degradation started with uniform corrosion作者: Decline 時間: 2025-3-31 02:27
