標題: Titlebook: An Introduction to Polymer Colloids; Fran?oise Candau,Ronald H. Ottewill Book 1990 Kluwer Academic Publishers 1990 chemistry.colloid.morph [打印本頁] 作者: 尤指植物 時間: 2025-3-21 16:57
書目名稱An Introduction to Polymer Colloids影響因子(影響力)
書目名稱An Introduction to Polymer Colloids影響因子(影響力)學科排名
書目名稱An Introduction to Polymer Colloids網絡公開度
書目名稱An Introduction to Polymer Colloids網絡公開度學科排名
書目名稱An Introduction to Polymer Colloids被引頻次
書目名稱An Introduction to Polymer Colloids被引頻次學科排名
書目名稱An Introduction to Polymer Colloids年度引用
書目名稱An Introduction to Polymer Colloids年度引用學科排名
書目名稱An Introduction to Polymer Colloids讀者反饋
書目名稱An Introduction to Polymer Colloids讀者反饋學科排名
作者: 無法治愈 時間: 2025-3-21 21:22
https://doi.org/10.1007/978-3-662-47841-7stable, whereas when particles associate to form aggregates or clumps, they are said to be unstable. The boundary between stability and instability is of major importance in the consideration of colloidal dispersions.作者: 凹槽 時間: 2025-3-22 02:54
Polymerization in Inverse Emulsions and Microemulsions,ymer particles dissolve rapidly, contrary to solid-powder polymer which forms gels or aggregates when added to water. These high viscosity polymer solutions find applications in, water-treatment, flocculation of colloidal suspensions, tertiary oil recovery as pushing fluids, fines retention in paper manufacturing etc. (1).作者: Panacea 時間: 2025-3-22 06:48 作者: Lineage 時間: 2025-3-22 09:46 作者: angina-pectoris 時間: 2025-3-22 14:23 作者: STENT 時間: 2025-3-22 18:24 作者: 慷慨援助 時間: 2025-3-23 01:11 作者: Melodrama 時間: 2025-3-23 02:07
Jeannette Prinzessin zu Fürstenbergdepend on the sequence distribution of monomer units along the main chains (microstructure) and this can lead to a particle structure which may result in a more or less complex morphology of the latex particles and of the films cast from them. As a consequence, it is necessary to control the synthesis in that heterogeneous process.作者: milligram 時間: 2025-3-23 09:00
Book 1990al conferences on an annual basis and many national ones as well. The interest stems not only from the wide range of applications of these materials but also from a curiosity as to the mechanism of formation and their growing use as model particles to investigate fundamental aspects of physics and c作者: 抵消 時間: 2025-3-23 11:10
nternational conferences on an annual basis and many national ones as well. The interest stems not only from the wide range of applications of these materials but also from a curiosity as to the mechanism of formation and their growing use as model particles to investigate fundamental aspects of phy作者: Vo2-Max 時間: 2025-3-23 14:45
Wehrstrukturen und Multinationalit?tportance during the polymerization process in order to ensure correct heat and mass transfer conditions and after polymerization, pumping and mixing the latex systems also require the correct viscosity. In fact the production of the polymer in the colloidal form is often the only way of acquiring the correct properties.作者: 澄清 時間: 2025-3-23 20:22 作者: 親密 時間: 2025-3-24 01:22
Copolymer Latex Morphology,depend on the sequence distribution of monomer units along the main chains (microstructure) and this can lead to a particle structure which may result in a more or less complex morphology of the latex particles and of the films cast from them. As a consequence, it is necessary to control the synthesis in that heterogeneous process.作者: 分發 時間: 2025-3-24 04:05 作者: HACK 時間: 2025-3-24 10:33
Preparation of Polymer Particles by Dispersion Polymerization, which emulsion polymerization has become the best known and arguably the most widely used process. While numerous early publications seemingly describe emulsion polymerization reactions, it was not until 1929 that processes which would now be considered as true emulsion polymerization reactions wer作者: CORD 時間: 2025-3-24 13:43
Polymerization in Inverse Emulsions and Microemulsions,process for producing high molecular weight polymers at high reaction rates. In this process, a water-soluble monomer (usually in aqueous solution) is emulsified in a continuous oil medium using a water-in-oil emulsifier. Polymerization can be initiated with either oil-or-water-soluble initiators. T作者: 愛花花兒憤怒 時間: 2025-3-24 16:36 作者: 油氈 時間: 2025-3-24 21:25 作者: 解脫 時間: 2025-3-25 00:15 作者: faction 時間: 2025-3-25 03:25 作者: collateral 時間: 2025-3-25 10:03
The Rheology of Polymer Colloids,ology is one of the major performance criteria are paints, adhesives, inks and fabric coatings. On the other hand, the flow properties are of great importance during the polymerization process in order to ensure correct heat and mass transfer conditions and after polymerization, pumping and mixing t作者: 河流 時間: 2025-3-25 13:00
Jeannette Prinzessin zu Fürstenbergays, biological cell-labelling, (identification and separation), and drug delivery systems. Small quantities of mono-disperse polymer colloids are used as size calibration standards and find extensive use to test theories in physics, colloids, and rheological studies.作者: Asparagus 時間: 2025-3-25 18:09
https://doi.org/10.1007/978-3-662-47841-7on polymerizations are usually more complex than the one cited above, often involving more than one monomer or surfactant, as well as the presence of protective colloids, chain transfer agents (‘modifiers’) and cross-linking agents.作者: CURT 時間: 2025-3-25 20:15
Emulsion Polymerization,ays, biological cell-labelling, (identification and separation), and drug delivery systems. Small quantities of mono-disperse polymer colloids are used as size calibration standards and find extensive use to test theories in physics, colloids, and rheological studies.作者: Maximizer 時間: 2025-3-26 03:20 作者: TOXIC 時間: 2025-3-26 05:32
Book 1990s, the colloidal properties of latices, characterization methods and rheology. It is hoped that these will serve a wide audience, undergraduates, graduate-students and research workers, both in industry and academe. The chapters all contain review material up to date at the time of publication. fhe 作者: 顯微鏡 時間: 2025-3-26 08:40
mer latices, the colloidal properties of latices, characterization methods and rheology. It is hoped that these will serve a wide audience, undergraduates, graduate-students and research workers, both in industry and academe. The chapters all contain review material up to date at the time of publication. fhe 978-0-7923-0600-9978-94-009-0521-4作者: MOCK 時間: 2025-3-26 13:45 作者: epicardium 時間: 2025-3-26 20:24
978-0-7923-0600-9Kluwer Academic Publishers 1990作者: fluffy 時間: 2025-3-26 23:30
http://image.papertrans.cn/a/image/155429.jpg作者: 不開心 時間: 2025-3-27 02:32 作者: 思考而得 時間: 2025-3-27 05:25
Jeannette Prinzessin zu Fürstenberg which emulsion polymerization has become the best known and arguably the most widely used process. While numerous early publications seemingly describe emulsion polymerization reactions, it was not until 1929 that processes which would now be considered as true emulsion polymerization reactions wer作者: 擦試不掉 時間: 2025-3-27 13:11
Jeannette Prinzessin zu Fürstenbergprocess for producing high molecular weight polymers at high reaction rates. In this process, a water-soluble monomer (usually in aqueous solution) is emulsified in a continuous oil medium using a water-in-oil emulsifier. Polymerization can be initiated with either oil-or-water-soluble initiators. T作者: 革新 時間: 2025-3-27 17:00 作者: largesse 時間: 2025-3-27 21:42
https://doi.org/10.1007/978-3-662-47841-7es. In general, particles of colloidal dimensions will be dispersed in a liquid environment and remain dispersed as a consequence of Brownian motion. On the other hand dispersions can often be subjected to quite adverse conditions such as, high shear, additions of electrolyte, high temperatures, fre作者: congenial 時間: 2025-3-28 00:03
https://doi.org/10.1007/978-3-662-47841-7ibits limited solubility in water but is completely miscible with its polymer, so that the latex particles formed become swollen by monomer; next, a surfactant must be present to promote the formation of the initial emulsion, as well as to impart colloid stability to that emulsion and to the latex p作者: Diverticulitis 時間: 2025-3-28 04:35
https://doi.org/10.1007/978-3-322-80576-8oach the problem of characterization by enumerating essential properties such as: (1) size range; (2) density or partial volume; (3) geometric and optical size; (4) anisotropy; (5) number concentration; (6) hydrodynamic size; (7) distribution functions; (8) surface philicity; (9) electrophoretic mob作者: 休息 時間: 2025-3-28 06:20
Wehrstrukturen und Multinationalit?tology is one of the major performance criteria are paints, adhesives, inks and fabric coatings. On the other hand, the flow properties are of great importance during the polymerization process in order to ensure correct heat and mass transfer conditions and after polymerization, pumping and mixing t作者: 小口啜飲 時間: 2025-3-28 13:40
Front Matter success of the conference was in part due to their generous contributions. The Program Committee had the unhappy task of the reviewing of more than 170 abstracts. The result of their labors was well worth their effort. Much thanks goes to them for molding the conference into an accurate representat作者: 變形 時間: 2025-3-28 16:23 作者: 領導權 時間: 2025-3-28 19:43
